Anyway it is was really hectic here for a while as we had to expand or move. Well we doubled our space and nearly doubled our membership so that went well, but shifting and moving and running enough power to the new wood shop took a bit of time.
But I am back at it again.
So the coffee table board is first up.
Thinking about a table with lots of holes in it and the thought of jamming bits of metal into them poses some different problems. I'm currently thinking I will have to develop some kind of plastic end for the components to avoid major gouging.
The thing is if I go that route maybe I should smarten up the whole thing. Since I'm tinkering with the connection should I go ahead and include the ablity to determine what component is plugged into what hole?