Week 4 - Sep 25 - Oct 01

 

Finally, the kit made its way home. And there you have the stunning pictures of the NUCLEO-L476RG kit.

Nucleo L476RG board sponsored from IoT on Wheels design challengeNucleo L476RG board with addons sponsored for IoT on Wheels design challenge

 

Below is the code for the "BLINK LED" program which is the "Hello World" program for electronics to test the Nucleo MCU board.

 

Digital Pins D8 & D13 have been chosen as output pins and have been declared differently. I love the way the LD1 changes from red to green when I feed in the program into the MCU board.

 

#include "mbed.h"
PinName digitalPin = D8;
int main() {
    // put your setup code here, to run once:
    DigitalOut myled(digitalPin);
    while(1) {
        // put your main code here, to run repeatedly:
        myled = 1; // LED is ON
        DigitalOut(D13, 0);
        wait(0.5); // 500 ms
        myled = 0; // LED is OFF
        DigitalOut(D13, 1);
        wait(0.5); // 500 ms
    }
}

 

 

For "Blink Led program" to begin your coding with Nucleo L476RG please visit this link.

For "Hello IoT program" to begin your coding with Nucleo L476RG with steps to start a project in the Mbed online compiler please visit this link.

 

Please find below links to my previous blogs on my traffic predictor project for IoT on Wheels design Challenge,

Blog 1 - The Official Announcement

Blog 2 - Quest for the code editor

Blog 3 - The Plan

Logo