This update is the wiring of the power to the globe. The below photos and explanations of each, describe exactly what I did. I also include a video at the end.

 

First photo is of the Positive wires that power the Raspberry Pi and the LED's:

 

 

Next is the Negative out:

 

 

Next photo is of the underside at the bearings. The spindle is hand made of wood on a wood lathe. I drilled a hole down the middle for the wire to travel:

 

 

The last is a video of the power connected turning on LED's:

 

 

Hope you enjoyed this update. As always, any questions, comments or ideas you have, please leave a message below!!

 

Dale Winhold