Skip navigation

GIZMO 2

3 Posts authored by: Frederick Vandenbosch Top Member
Previous posts: Gizmo2: 3D Printable Enclosure - First Iteration Gizmo2: Adding external PWR and RST buttons   Introduction Live USB Stick mSATA SSD Physical Installation SSD Detection Modification Software Installation Conclusion   Introduction  Using a Live USB Stick, I failed to install Ubuntu (or Xubuntu, tried both) to the microSD card of the GIZMO 2. The installation would finish successfully, but afterwards it was impossible to boot fro ...
Introduction Buttons Demo   Introduction  In my previous post, I designed and 3D printed an enclosure for the Gizmo2. Unfortunately, this blocks access to the onboard power and reset buttons. So I searched for a way to have some external buttons which I could eventually mount to the enclosure.     Buttons  The process to find where I could connect my buttons to was rather simple actually. Using my multimeter, I searched for connections between the buttons a ...
Introduction Design Print   Introduction  To protect my brand new GIZMO 2 board from the pointy and metal objects (and the rest of the mess) scattered around my desk, I decided to design a simple 3D printable enclosure for it, which would still expose all interfaces. I'm no professional designer, so it's more a functional enclosure rather than a fancy looking one   I took various measurements of the board, especially around the ports and started porting this to Sket ...