Version 1

    Dear Vishay Foil Resistors Customers:

     

    I’m pleased to announce a new addition to our library of Facts At a Glance technical articles: “When Small Isn’t Better in Precision Resistor Applications.”

    The drive towards smaller and smaller devices demands smaller and smaller precision resistors handling greater and greater power densities. Usually this means that surface-mount chip resistors should be used whenever possible. Or does it? SMT technology is not without its trade-offs. Excess heat, board flex stress, and microphonic noise are just a few of the typical downsides of using surface-mount components in precision applications. More often than not, the best choice is a through-hole precision resistor.

    Find out more here: http://www.vishaypg.com/doc?63520

    To be notified when new Facts at a Glance are added, or when there’s other news from Vishay Foil Resistors, be sure to follow us at http://www.twitter.com/FoilResistor.

     

    Further information about VFR products is available at: www.vishayfoilresistors.com

    Follow Vishay Foil Resistors at LinkedIn (New) : http://www.linkedin.com/pub/yuval-hernik/79/4b9/89/

    Follow Vishay Foil Resistors at: http://twitter.com/foilresistor

     

    Bulk Metal is a registered trademark of Vishay Precision Group, Inc.

     

    With Regards,

    Yuval

     

    Vishay Precision Group

    3 Great Valley Parkway, Suite 150 • Malvern, PA USA Phone +1-484-321-5300 Fax +1-484-321-5301

     

    If you do not wish to receive announcements like this one, please respond to this email with the subject line “unsubscribe.” Thank you.