Win an Raspberry Pi 3 and Raspberry Pi Cloudio Dev Board!
In this episode, Clem was not satisfied with the wireless transmission for the movement data - "it kinda works, but it's really laggy."
Your challenge is to describe a design or code approach to send data wirelessly from the MPU6050 to the Raspberry Pi (or another Arduino) so Clem can remove the wired connection to the Pi's USB port.
Submit your entry in the comments below by 26-November, 2018.
Clem will select the winner on 30-November.
PowerBoost 1000 LiPo Charger 5V 1A Boost
Rechargeable Battery 3.7 V Lithium Polymer 1100 mAh Connector
|Stripboard, FR2, Epoxy Paper, 1.5mm, 160mm x 100mm||KEMO ELECTRONIC||1|
|Arduino Micro ATmega32U4 MCU 20 3.3V I/O 12 Analogue Inputs ISCP Header||ARDUINO||2|
|Raspberry Pi 3 Model B+, BCM2837B0 SoC, IoT, PoE Enabled||RASPBERRY-PI||1|
|Integral 16gb MicroSD Card with Adapter||INTEGRAL||1|
|TRANSMITTER 433.92MHZ 3KBPS SIP||RF SOLUTIONS||2|
|RF RECEIVER MODULE, 433.92, -110DBM||RF SOLUTIONS||2|
|RIBBON CABLE 10 CONDUCTOR 28AWG 300V||3M||1|
|Joystick 2 6 A 240 V||KELAN||1|