If you followed Part 1 without issue, move on to Part 2 below. If not, please go back and get Part 1 completely correct, otherwise it will have a ripple effect across the whole project.


Section 2: Now you can run your first application on your device in debug mode.


2.1. Put your device in debug mode:

azsphere device prep-debug



2.2. Open Visual Studio:


2.3. Create New Project:


2.4. You can just Run Project on your Device:

You should see the green LED blinking on the Azure Sphere.


2.5. Stop the application by pressing.


Now we move onto Part 3, where we will create a new project.