Dave Jone's Of The EEVBLOG did some posts on a DIY PSU around a year back. This project is a spin off of that and I made some changes according to my liking and finally made a PCB that I can use. There are still some things that need to be done.

I made a small video for the same which is linked below.

 

 

The major differences in this version are as follows:

1. Voltage reference is 4.096V

2. Buttons for interface.

3. Cheaper LCD.

4. 10 1Ohm Resistors

 

Will share schematic once I get Eagle up and running again.(PC cleaned!)

 

Lemme know what you think.

Thanks.

IP