3 Replies Latest reply on Jun 12, 2019 8:04 AM by mega128

    Allow autorouter to route on keepout fills

    mega128

      I don't have a specific board in question, just in general, I would like to make certain fills as keepout but I want autorouter to route through it.

       

      I know it is opposite of regular way I am asking, but it is possible? For now, in my library pcb of a component, I am saving the fills another layer such as top test point before autorouting, after auto routing, I change these polygons to keepout layer. However, this is time consuming. I was wondering if there is a way in Autorouter rules or somewhere where Auto router can route through those areas. I am saving this keepouts i component footprint so I don't have to draw them manually in PCB editor.

       

      Thanks everyone,