14 Replies Latest reply on Jan 1, 2013 2:55 PM by ash068

    I've killed my gertboard ! ( and havent even finished it )

    ash068

      Well this is amusing.. Whilst attempting to solder one of the grains of sand in the kit,  I've managed to burn a couple of surfacemount pads on the board  .  It's on one of the resistors,  I think I had the iron way to hot.

       

      I was wondering ( hoping )  if anyone could advise on a way to fix it..

       

      Thanks in advance.

       

       

      Ash.