Raspberry Pi

1 update since last visit
Announcement 1 We're Giving Away Two Ben Heck Hex Game Prototypes!
Announcement 2 Atari Dragster Speed Test Record - Man vs ComputerAnnouncement 3 Project14 | Anything Goes with Cool LED Display Projects!Announcement count
Profile Photo
Hello There, Anyone Please help me with Modbus. I am completely new with modbus I am Stuck here. I have to make my Raspberry pi as slave device which will response to modscan32 software. Currently i am using libmodbus stack, but it constantly popping the error that "modbus.h, no such file or directory." I am using RX TX gpio pins for Data… (Show more)
Profile Photo
Click to view larger image     Kyber Crystals     https://www.instagram.com/trent_darkside/
Profile Photo
I have seen a lot of guides to configure headless operations without attached display, keyboard, and mouse - all of which seem to be out of date.  Maybe it's because that Raspbian has evolved or something else.  Anyways, this technote is based on Raspbian Stretch or Stretch-Lite circa September 2017.   I got this Raspberry Pi Zero "W" for USD… (Show more)
Profile Photo
i had try so many code and thing but i dont get the correct answer for how to transmitter or receive the data through GPIO pin of serial port
Profile Photo
I was looking for a power switch or button for the Raspberry Pi 3. Does anyone have a recommendation on a good switch?
Profile Photo
Hi, I'm facing a problem running babel on my raspberry pi model B   here are the steps which I made:   1. installation # sudo apt-get install babeld   2. running bable deamon on wlan0 # sudo babeld wlan0   An error message appeared –> Couldn’t read forwarding knob.: No such file or directory kernel_setup failed   I am new in linux and im trying… (Show more)
Profile Photo
Hola. Recientemente adquirí la pantalla oficial de 7". Tengo una Raspberry Pi 3. La carcasa que tengo me obligo a girar la imagen de la pantalla. Desde ese momento El táctil no responde bien. Antes de girar pantalla funcionaba bien. He probado a usar software de calibracion y sdigue sin funcionar. Tengo RASPBIAN STRETCH WITH DESKTOP con kernel… (Show more)
Profile Photo
Sorry, I am new to the Raspberry Pi, RetroPie, and the forums here in general, but I have tried a bit of troubleshooting on my own and seem to be getting nowhere. I tried searching the forum here for this issue, and while I found a couple posts related, none seemed to be dealing with the issue "out of the box" but had it crop up while they were… (Show more)
Profile Photo
Hello,   I am trying to find a reliable supplier who could handle an order >1,000. Does anyone know where I should start? I have tried to contact RaspberryPi.org but have not received a response yet. Thank you to anyone who can help!   Best Regards, Brendan
Profile Photo
Click to view larger imageThis is a light stand for the official Raspberry Pi 7"touchscreen Display. It is designed for quick prototyping as it is lightweight and takes little time to print. 4 pcs M3-0.5x5mm or M3-0.5x6mm screws are needed. At the beginning of the design I couldn't decide what was the best angle so I ended up designing 3 stands with with different angles… (Show more)
Profile Photo
Hi,I am new to raspberry pi compute module. I was working with the cm3 lite before this with a full desktop version installed and hence had no problems with the camera modules. Since my cm3 lite got short i have to use the cm3 with flash memory which has the jessie lite version installed. I did the procedure in the rpi in order to support dual… (Show more)
Load more items