I have decided to update my Fuel Load Indicator which has only outputs for a human. My goal is to Recycle & Retrofit this indicator so that it can talk over the CANaerospace network. The network responds to node 0 for multicast, and also nodes 668 - 675 (tank_1 - tank_8).
I have not been able to get the display to fire up with the pinouts here. Starting from the beginning I have gotten somethings wrong, ie the pinouts of the display connector.
On most IDE connectors the side with the notch is pin 1 on the right.
Not so this time the side without the notch and on the right. So here are the pinouts that I have found.
I have identified pin 1 by looking at the pins on the bottom of the display under magnification, and I found one of the pads square notifying pin #1.
The table on the right is correct for pin-outs (I hope) ---> (DB-b has a notch, DB-a does not)
( He should find his way to engineer hell)
|U1 Control Lines||5|
|U2 Control Lines||5|
|Other Control Lines||2|