4 Replies Latest reply on Sep 9, 2017 1:30 AM by Autodesk Guest

    How to unfill a polygon after ratsnet

    gussabina

      Hi:

       

      Once you create a polygon for a ground plane, and after using Ratsnet, the polygon fills. How to get rid of the fill again (other than closing and opening the .brd again)?

       

      Thanks;

      Gus

        • Re: How to unfill a polygon after ratsnet

          Op Sun, 29 Jul 2012 18:34:51 +0200 schreef Gus Sabina 

          <noreply-116942@element14.com>:

           

          Hi:

           

          Once you create a polygon for a ground plane, and after using Ratsnet, 

          the polygon fills. How to get rid of the fill again (other than closing 

          and opening the .brd again)?

           

          Thanks;

          Gus

           

           

          Hi Gus,

           

          Use RIPUP on an edge of the polygon. HELP RIPUP

           

          Richard

           

          • Re: How to unfill a polygon after ratsnet

            On 7/29/2012 12:34 PM, Gus Sabina wrote:

            Hi:

             

            Once you create a polygon for a ground plane, and after using Ratsnet, the polygon fills. How to get rid of the fill again (other than closing and opening the .brd again)?

             

            Thanks;

            Gus

             

             

            Hi Gus,

             

            You can type:

             

            RIPUP @;

             

            Followed by enter in the EAGLE command line.This will return all of the

            polygons to outline mode.

             

            hth,

            Jorge Garcia

             

             

             

            1 of 1 people found this helpful