14 Replies Latest reply on Jan 29, 2017 12:27 PM by anishkgt

    Double sided PCB design

    anishkgt

      Hi all,

       

      Since i've started using Eagle, i am now very much familiar with designing one sided. I thought i'd try out double sided.

       

      My idea is to design a PCB with a 11pin connector on one side, 8 led on the other and a POT. So that the connector do not come in the way of the LED when mounting the PCB. below is my design just need some advise if the below design is ok as a double sided design before i send it to the fab house.

       

      Display Board TOP.png Display Board BTM.png