3 Replies Latest reply on Jun 20, 2017 1:22 PM by tarribred61

    PDF Schematic Output job

    jimku

      In CircuitStudio, I am trying to setup my schematic page output job (Project - Generate Outputs - Documentation - Schematic - page setup) to Leger(11x17) but this is not a selection. This is a common size to output schematics since most office printers have this size and its twice the size of letter size (8.5x11). I can directly print to this size using the Print documentation but would like to generate a pdf using the output job. Am I missing something in a setup somewhere?