There is a ULP provided with EAGLE called copy-arrrib-sch-to-brd. Execute this with the RUN command in the schematic and it should copy all the attributes over from the schematic to the board.
Thank you for your response.
I tried the ULP and it seems to work. Unfortunately, after running it I noticed that this attribute gets display on layer 21 'tPlace' on the board, overlaying other drawings that I had previously in there.
Is there anyway to avoid this? I don't want to display the attributes on the board. I could turn manually the the 'display' setting in every single object, but I have too many of them.
I tried to take a look in the ULP in order to change this, but I'm not very familiar with ULPs.
Do you have any ideas?
I'm adding to some components in the schematics an attribute 'OC_FARNELL' with its corresponding ordering number.
After doing an ERC, I get the following errors:
'Attribute of part X not found in board'
and I get the following warning when I open the board:
Board and schematic are not consistent!
No forward-/backannotation will be performed!
Use the ERC command to get a detailed error report.
How could I solve this?
I would appreciate your tougth on this.
PS: I'm using Eagle 8.3.2