2 Replies Latest reply on Mar 13, 2018 8:18 PM by prairietech

    Eagle Lite Board Size Question (again)

    prairietech

      I have a board with coordinates 0.00,0.00 when the cursor is in the lower left corner and 78.74,99.06 with the cursor in the upper right corner.

      I placed all of my components jammed up inside the lower portion of the box that indicates the board size. None of the components is outside the line.

      When I try and move any of the components toward the upper part of the board which is empty, I get the Eagle Lite limitation error message.

      What am I not understanding about the board limitation of smaller than 80mm x 100mm?

        • Re: Eagle Lite Board Size Question (again)
          Autodesk Guest

          On 03/12/18 20:38, Randy Nelson wrote:

          I have a board with coordinates 0.00,0.00 when the cursor is in the lower left corner and 78.74,99.06 with the cursor in the upper right corner.

          I placed all of my components jammed up inside the lower portion of the box that indicates the board size. None of the components is outside the line.

          When I try and move any of the components toward the upper part of the board which is empty, I get the Eagle Lite limitation error message.

          What am I not understanding about the board limitation of smaller than 80mm x 100mm?

           

          The maximum X coordinate is 100mm, maximum Y coordinate is 80mm.

          Anything you try to place above 80mm Y axis is is outside the limits.

           

           

          1 of 1 people found this helpful
          • Re: Eagle Lite Board Size Question (again)
            Autodesk Guest

            On 03/12/18 20:38, Randy Nelson wrote:

            I have a board with coordinates 0.00,0.00 when the cursor is in the lower left corner and 78.74,99.06 with the cursor in the upper right corner.

            I placed all of my components jammed up inside the lower portion of the box that indicates the board size. None of the components is outside the line.

            When I try and move any of the components toward the upper part of the board which is empty, I get the Eagle Lite limitation error message.

            What am I not understanding about the board limitation of smaller than 80mm x 100mm?

             

            The maximum X coordinate is 100mm, maximum Y coordinate is 80mm.

            Anything you try to place above 80mm Y axis is is outside the limits.