7 Replies Latest reply on May 8, 2018 9:12 AM by bugrobotics

    Board Outlines - How to Double Check

    baudot

      What tools outside CircuitStudio can I use to check my board outlines for correctness?

       

      My issue: After I output my design to gerbers, zip those up, and upload to Osh Park, I get the message back that my board outline is a mere 0.04 x 0.07 inches. The board outline I set up during editing is 600x600 mils, so that shouldn't be correct. Osh Park support reports that the outline file doesn't contain the board outline at all: It only has the pad for a single resistor in it. Looking over the outline file in this online tool backs up Osh Park's assertion: I see the pad for one of the board resistors, not a board outline.

       

      What could cause this sort of error when outputting to gerbers?