6 Replies Latest reply on Jun 2, 2021 9:12 AM by ker

    STEP file output won't include vias

    chuckbluz

      I am trying to export a STEP file so my mechanical engineer can verify fit in the product housing. However the only vias and pads that are exported are those associated with a connector on the PCB. Even if I check all three selections in the Export Options menu, In other words the "Export Free Pad Holes" and "Export Mechanical Component Pad Holes" don't seem to work. This is critical, since some of these pads are used for alignment of the PCB into the housing during manufacture.

       

      export options menu