1 Reply Latest reply on Aug 5, 2019 11:19 AM by jafoste4

    PCIe 20 degree bevel

    eric2pg

      Hiya.

       

      I creating my own PicoZed 7z015 carrier card with a PCIe edge connector.  I'm following the PicoZed Carrier Card V2 schematics and most of the board fab details I've found are in this document:

      http://zedboard.org/sites/default/files/documentations/PZCC_FMC2_Rev1_Layout_160321.PDF

       

      One of the things I've noticed on the PCIe female connector side is that the card connector is supposed to have a 20 degree bevel on its edges:

      https://cdn.amphenol-icc.com/media/wysiwyg/files/drawing/10142333.pdf

       

      I see that the physical PicoZed Carrier Card V2 as well.

       

      I'm using Altium, is there any special way to designate this bevel in the layout or fab documents?

       

      Thanks!