5 Replies Latest reply on Sep 10, 2019 9:45 PM by clem57

    Sphere wont connect to WiFi

    kelvic3d

      Hello,

       

      For the last week or so, my sphere wont connect to my Wifi. It appeared to start happening at the same time I had to have my router replaced because of a storm. The new router is almost identical to the old one and I set it up with the same SSID and key that I had on the previous one.

      This is the response I get from the show-status comamnd

       

      Configuration state : unknown
      Connection state    : disconnected
      Security state      : unknown
      Frequency           :
      Mode                :
      Key management      : UNKNOWN
      WPA State           : SCANNING
      IP Address          :
      MAC Address         : **:**:**:**:**:**   (disguised)

      Command completed successfully in 00:00:01.6956155.

       

      This what the list command outputs

       

      Network list:

      ID                  : 0
      SSID                : KELVIC-Net5G
      Configuration state : enabled
      Connection state    : disconnected
      Security state      : psk

      ID                  : 1
      SSID                : KELVIC-Net2.4
      Configuration state : enabled
      Connection state    : disconnected
      Security state      : psk

      Command completed successfully in 00:00:01.9069631

       

      Any clue to whats going on? The Shpere was not physically connected during the storm and appears to work fine other then it wont connect to my WiFi. It has been logging into the contest server all week w/o the wifi connected.