3 Replies Latest reply on Oct 10, 2019 5:43 PM by bhfletcher

    I/O voltage pins on Ultra96-V2 for CANBUS

    nico_n04

      I saw that the header expansion uses 1.8V.  I have added canbus support to the slow speed expansion header (J7).

      the slave devices I am using on the buses uses 3.3 Volts , I saw on a forum that I can use a level shift but  I would rather use 3.3 Volts directly from the board.

       

      Is the way to configure the board to use 3.3 Volts for the VCC_PAUX from the schematics?

      I would assume the high speed expansion header also uses 1.8 V as well? is there a set of pins from one of the banks set to use 3.3 Volts?