0 Replies Latest reply on May 10, 2020 9:09 AM by ungedanielsen

    Eagle 9.2.2 free and pcb-gcode 3.6.2.4 issues

    ungedanielsen

      Hello all.

       

      I am quite new to this, but I have an issue.

       

      Trying to produce gcode to mill my board, but the gcode that comes out of pcb-gcode is just wrong..

       

      Here is the Bottom layer in Eagle:

       

       

      Here is what the preview generates (Looks correct):

      And here is what the preview of the gcode looks like:

       

       

      The Drill-file looks good.

       

      Any pointers on what I am doing wrong?