I'm currently designing a mezzanine card to mate to ZedBoard as the primary demonstration host controller and I have been asked by my layout designer to procure either the gerber files (not PDF) or DXF files for a minimum of the primary layers so that we can build a to scale model of the board in Cadence Allegro. The goal of this is to ensure that mechanically we have oriented the FMC connector and any mounting holes correctly to ensure proper mating to the Zedboard.
Any help you can provide is appreciated.
You can request this through your local Avnet FAE. If you don't know who your FAE is, then use one of the Location links below.
Europe / Middle East