4 Replies Latest reply on Aug 27, 2020 10:21 AM by drozwood90

    Vivado Hardware manager does not detect any devices on the UltraZed-EG SOM board

    eran99

      I'm connected to the Avnet UltraZed-EG SOM board using DLC10 USB-JTAG

      adopter.
      when I click on open-target and then auto-connect, the DLC10 is detected, and the UltraZed-EG is detected - I know that since it says:

      Xilinx_tcf/Xilinx/00001877ae8201(0) "open", but if I unplug the jtag connector is says "closed".

      However, it says Device Count 0 under properties, and I'm getting a message " No devices detected on target"

       

      I set all 4 DIP switches to ON, which is 0000 for JTAG boot mode.

       

      Is there any other setting or jumpers I need to deal with on the UltraZed board, or perhaps it's a driver issue?

       

      Eran