0 Replies Latest reply on Sep 25, 2020 7:15 AM by jonasss

    Unwanted/confusing net selection by "select connected copper"

    jonasss

      Hi Everyone,

       

      I'm having a hard time figuring out what's going on with the "select connected copper" tool.

       

      In the picture below I use this tool and it selects all the tracks from connection a to b, just like expected.

       

       

      But when I then edit the track - purpose is for length matching - and I use the same tool "select connected copper" it selects all GND tracks as seen in the following picture.

       

       

      There is no obvious connection from the track that I want to connect (SDX2) to that GND. Am I missing something?

       

      When I use "select physical connection" it then selects the tracks correct from a to b, like expected. BUT the select connected copper also selects other nets, which is a real scary thing!

       

       

      Any help much appreciated!

       

      Best Regards

       

      Jonas