3 Replies Latest reply on Oct 21, 2020 1:34 PM by narrucmot

    USB and WiFi interfaces

    talvlad29

      Hello,

      I use 2019.2 Vivado, Vitis and Petalinux versions to build my design and Linux configuration. My design includes USB 3.0 interface and WiFi (wilc driver 15.2). I successfully connect Ultra96v2 board to WiFi and get remote access to the board via SSH (I use OpenSSH) if there is no external USB devices. It works well if I plug USB 3.0 device to J9 USB connector. However, I SSH gets hang if I plug USB device to J8 connector. SSH comes back after unplugging USB device from J8 connector. What can cause this issue?

      Thank you,

      Vladimir